November 27, 2018

ASTM E92 PDF

This standard is issued under the fixed designation E92; the number immediately 1 These test methods are under the jurisdiction of ASTM Committee E28 on. Astm e92 Vickers Hardness of Matallic Materials – Free download as PDF File . pdf), Text File .txt) or read online for free. priate safety and health practices and determine the applica- bility of regulatory limitations prior to use. 2. Referenced Documents 2. 1 ASTM Standards.

Author: Gotaur Disho
Country: Zambia
Language: English (Spanish)
Genre: Career
Published (Last): 11 July 2009
Pages: 88
PDF File Size: 14.46 Mb
ePub File Size: 15.81 Mb
ISBN: 582-6-83874-269-8
Downloads: 39624
Price: Free* [*Free Regsitration Required]
Uploader: Shakazahn

Other materials may require special considerations, for example see C and C for ceramic testing. The Vickers asrm Knoop hardness numbers were originally defined in terms of the test force in kilogram-force kgf and the surface area or projected area in millimetres squared mm 2.

ASTM E92 – VICKERS HARDNESS

It is the responsibility of the user of this standard to establish appropriate safety and health practices qstm determine the applicability of regulatory limitations prior to use. Hardness, although empirical in nature, can be correlated to tensile strength for many metals, and is an indicator of wear resistance and ductility.

TOP Related  RAJPUT VANSHAVALI PDF

Link to Active This link will always route to the current Active version of the standard.

Today, the hardness numbers are internationally defined in terms of SI units, that is, the test force in Newtons N. While Committee E28 is primarily concerned with metallic materials, the test procedures described are applicable to other materials.

This rise in hardness number with lower test forces is often more significant when testing higher hardness materials, and is increasingly more significant when using test forces below 50 gf see Test Method E However, because of the historical precedent and continued common usage, force values in gf and kgf units are provided for information and much of the discussion in this standard as well as the method of reporting the test results refers to these units.

For isotropic materials, the e992 diagonals of a Vickers indentation are equal in length. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Hence, the Knoop hardness test is very useful for evaluating hardness gradients since Knoop indentations can be made closer together than Vickers indentations by orienting the Knoop indentations with the short diagonals in the direction of the hardness gradient. However, in practice, asgm most commonly used force units are kilogram-force kgf and gram-force gf.

TOP Related  ASTM E122 PDF

Standardization of Vickers and Knoop Indenters. Microindentation hardness tests also allow specific phases or constituents and regions or gradients too small for macroindentation hardness testing e992 be evaluated.

Historical Version s – view previous versions of standard.

The significant differences between the two tests are the geometries of the respective indenters, the method of calculation of the hardness numbers, and that Vickers hardness may be used at higher force levels than Knoop hardness. Vickers and Knoop Hardness Standardizing Machines.

ASTM E92 – 17 Standard Test Methods for Vickers Hardness and Knoop Hardness of Metallic Materials

This standard provides the requirements for Vickers and Knoop hardness machines and the procedures for performing Vickers and Knoop hardness tests. When Newton units of force are used, the force must be divided by the conversion factor 9. Recommendations for microindentation testing can be found in Test Method E